Guia de Alinhamento de Rádio Vintage

Guia para alinhamento de rádio vintage

Vintage Radio Alignment Guide

IF and RF alignment procedures for tube radios

Safety Warning: Tube radios contain lethal voltages (200-300V+). Always use an isolation transformer. Discharge capacitors before servicing. Never work on a powered chassis with both hands.

Band Type

Standard IF Frequency

455 kHz

Standard AM IF frequency used in virtually all AM tube radios

Step 1: IF Alignment

1Set signal generator to 455 kHz, 30% modulation at 400 Hz
2Connect generator output through a 0.01μF capacitor to the converter grid
3Connect VTVM or oscilloscope to detector output (across volume control)
4Keep generator output as low as possible for usable meter reading
5Adjust last IF transformer slug for maximum output reading
6Adjust preceding IF transformer slugs in sequence, working toward the front end
7Repeat all adjustments 2-3 times for best accuracy (transformers interact)
8If meter reading goes off scale, reduce generator output, do not change meter range

Step 2: RF / Oscillator Alignment (High End)

1Set signal generator to 1400 kHz, 30% modulation
2Set radio tuning capacitor to 1400 kHz on dial
3Connect generator through radiation loop or loosely coupled wire
4Adjust oscillator trimmer capacitor for maximum output
5Adjust antenna trimmer capacitor for maximum output
6Check dial calibration accuracy at this frequency

Step 3: Tracking Adjustment (Low End)

1Set signal generator to 600 kHz, 30% modulation
2Set radio tuning to 600 kHz on dial
3Adjust oscillator padder capacitor (series trimmer) for maximum output
4Rock tuning capacitor slightly back and forth while adjusting for peak
5Recheck 1400 kHz alignment (may need iteration)
6Verify tracking at 1000 kHz — should be close without adjustment

Required Equipment

Signal GeneratorProvides calibrated RF test signals at alignment frequencies

VTVM or OscilloscopeMeasures output level for peak detection during alignment

Alignment ToolNon-metallic hex or blade tool for adjusting IF slugs and trimmers

0.01μF Coupling CapacitorIsolates signal generator from tube grid DC voltage

Isolation TransformerSafety — isolates radio chassis from AC mains

Dummy AntennaSimulates proper antenna impedance for RF alignment

Alignment Tips

Always perform IF alignment before RF alignment
Use the weakest usable signal from your generator
IF transformers interact — repeat adjustments 2-3 times
Never use a metal screwdriver near live circuits
Mark trimmer positions before adjusting so you can return to starting point
For FM, a sweep generator gives the best visual alignment results

Obtenha resultados precisos rapidamente com este guia gratuito de alinhamento de rádio vintage. Tudo é executado localmente no seu navegador para máxima privacidade.